1. CTOUCH Support
  2. Leddura 2Meet
  3. FAQs

Menu

    How can I upgrade the RS232/MCU Firmware on Leddura 2Meet?

    Avatar
    Willem Jan van der Meer
    Follow

    In the occasion you want to make use of RS232 communication with our touch screens and you want to make use of the latest added commands, you need to upgrade the MCU firmware. Since the MCU firmware works in close cooperation with the main firmware, it is mandatory to also upgrade the main firmware of the touch screen.

    WARNING! Firmware Update is a responsible operation, during which control software of the device will be changed. All damage induced by the upgrade will void warranty and might require treatment by the service center. Please perform the upgrade procedure in accordance with the instructions below. In case of any doubt, please contact your dealer/reseller.

    Required:
    USB to RS232 Cable TIP: https://docklight.de/information/#docklight-RS232-Adapter
    Windows Laptop
    FlyMCU Software
    ST32F103.hex File

    Preparation:
    1. Shut down the CTOUCH 2Meet and power off via Power switch near the power plug

    2. Connect the CTOUCH 2Meet and Windows Laptop with the USB to RS232 cable.

    3. Start up Fly MCU executable on your Windows laptop

    4. Verify that both the “Port” and “bps” are set to the correct values.
    The “Port” must correspond with the COM address the “RS232 to USB” cable identifies as. The bps should be set to the baud rate used by CTOUCH 2Meet. This would be 9600 out of the box.

    5. Press the “Browse” button next to the “Code File For Online ISP” field.

    6. Browse to the “ST32F103.hex” file and open this. You should now have the correct file selected.
        The window should now show the correct path in the “Code File For Online ISP:”

     

    Updating the MCU File:

    7. Press “Start ISP(P)”
    The window should now show it is awaiting a pending connection like shown below.

    8. Hold the “Center button” on the CTOUCH 2Meet and switch the Power switch on.


    9. When you have done this correctly and within a timely fashion you will see progress on the FlyMCU window until complete like shown below.

    10. When complete please unplug the RS232 cable and restart the CTOUCH 2Meet

     

    In case the automated upgrade process is unsuccessful:

    In the rare case that above procedure is not successful, please take the next steps to get the MCU updated:

    1. Power Off the set via Power switch near the power plug.

    2. Select the option 'Erase Chip(Z)' in FlyMcu:

    3. Power On the set via the Power Switch and hold the Home button for a few seconds. Erasing starts.

     

    4. Power Off the set via Power switch near the power plug.

    5. Select the option 'Start ISP(P)':

    6. Power On the set via the Power Switch and hold the Home button for a few seconds. Upgrading from MCU starts.

    7. When Done, please disconnect RS232 cable and Power Off / On the set via the Power Switch near the power plug.